Rechargeable LED interior light.
You can switch the brightness to 4 levels.
Body size H175xW125xD115mm Box size H180xW130xD120mm
Silicon, LED module (lithium ion battery)
USB Type-C charging cable
[Charging time/Using time]
2.5-3 hours/Less than about 13 hours Strong About 6 hours
Made in CHINA
【how to use】
① Turn on the power switch on the bottom of the main unit. ② The color and brightness of the light can be changed by tapping the main unit or the desk on which it is placed in response to vibrations. Light bulb color, low → Light bulb color, strong → Daylight color, weak → Daylight color, strong → Off ③ After use, turn it off using the power switch on the bottom of the main unit.
- Insert the included charging cable into the bottom of the main unit and connect it to a USB power source to charge. - The light on the bottom of the main unit lights up red while charging, and the green light lights up when charging is complete.
[Precautions for use]
Please read the "Precautions for Use" carefully before use, and use the product correctly. Please do not use it for any purpose other than its intended purpose.・Do not store, leave, or use the product near firearms or heating equipment, or in high-temperature locations.・It is not waterproof. Do not use outdoors. Do not use the product in areas with large temperature differences as this may cause condensation.・Do not subject the product to strong impacts such as hitting it or dropping it. It will be the cause of the failure.・Due to the characteristics of silicone, it will turn yellow over time. Avoid exposing it to direct sunlight as much as possible.・Do not use by small children. Also, keep it out of reach of infants and pets.・Do not disassemble or modify the LED module. Batteries cannot be replaced.
–Notes on charging–
・If charging does not complete for a long time, please stop charging. There is a risk of fire due to overcharging.・If the output from the power supply side is insufficient, charging may not occur.・You cannot use adapters for quick charging. Please use an adapter with an output of 1A~2A to ensure product safety.・Regularly remove dust and dirt stuck between charging terminals and adapters.
–About how to care–
- If the silicone gets dirty, wet a soft cloth, wring it out thoroughly, and wipe it gently. - If the dirt is difficult to remove, remove the LED module from the main unit, dampen a cloth with a neutral detergent diluted with water, and gently wipe it off.・When disposing of the product, please dispose of it according to the disposal classification of each local government.